Firmware for Gremsy T3v2

Created by Gremsy Support, Modified on Thu, 08 Dec 2022 at 02:55 PM by Gremsy Support

Gremsy T3 V2 uses its own firmware and is different from Gremsy T3. Please double check your T3 version by looking at the Roll axis.

What's new in firmware version 6.1.0?

Added :

  • Support Mavlink 2
  • Home position
  • Set home position
  • Mapping mode and custom mapping angle.
  • Lightbridge 2 operartor :
    + C1 on/off motor
    + C2 change mode
  • Pixhawk supported


Firmware :

Software :

Note : T3 V2 firmware 6.1.0 supports Mavlink 2 so please upgrade firmware via Gtune 1.3.3 or lower then switch to use Gtune 1.3.6.

In case you forget how to send the new firmware to your gimbal, please refer to this link: How to upgrade/downgrade Gremsy Gimbal Firmware?

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select atleast one of the reasons

Feedback sent

We appreciate your effort and will try to fix the article