1. INSTALL JOYSTICK TO RING OR HANDLE
Learn more at :
2. JOYSTICK CONNECTION
Connect SBUS cable from joytick to SBUS port located on the Hyper Quick Release
3. ASSIGN SBUS CHANNELS
Go to SETTINGS -> CONTROLS -> SBUS
Select FASST protocol and assign channels as below
4. SBUS JOYSTICK MODULE OPERATION
4.1. DEACTIVATE SBUS JOYSTICK MODULE
If joystick is in active state, hold and press button 3 secs will change its state to inactive state LED Status on gimbal: GREEN
4.2. ACTIVATE SBUS JOYSTICK MODULE
If joystick is in inactive state, hold and press button 3 secs will change its state to active state. Moreover, using button allows joystick to enter different modes :
- CONTROL: Normal operation where user can control tilt and pan, LED status is BLUE
- SET SPEED: Press button 2 times to enter SET SPEED mode, LED status will change from BLUE to GREEN.
Speed of each axis is adjustable from 1 to 10 level, default is 5.
• Set TILT SPEED:
Move tilt stick to maxium travel T+ and back to center x times will increase tilt speed by x level (x=1...10).
Move tilt stick to maxium travel T- and back to center x times will decrease tilt speed by x level (x=1...10).
Press button 1 time to return to CONTROL mode and LED will turn to BLUE again.
• Set PAN SPEED :
Move pan stick to maxium travel P+ and back to center x times will increase tilt speed by x level (x=1...10)
Move pan stick to maxium travel P- and back to center x times will decrease
pan speed by x level (x=1...10)
Press button 1 time to return to CONTROL mode and LED will turn to BLUE again
- SET DIRECTION:
Press button 3 times to enter SET DIRECTION mode, LED status will changefrom BLUE to GREEN.
• Set TILT DIRECTION:
Move tilt axis to maxium travel (T+ or T-) and back to center to change TILT direction
Press button 1 time to return to CONTROL mode and LED will turn to BLUE again
• Set PAN DIRECTION:
Move pan axis to maxium travel (P+ or P-) and back to center to change PAN direction
Press button 1 time to return to CONTROL mode and LED will turn to BLUE again